Cast
& Splint Care…
Splints
and casts support and protect injured bones and soft tissue,
reducing pain, swelling, and muscle spasm. In some cases,
splints and casts are applied following surgery.
Splints
or "half casts" provide less support than casts.
However, splints can be adjusted to accommodate swelling
from injuries easier than enclosed casts. Your doctor will
decide which type of support will be best for you.
Types
Of Casts And Splints
Casts are custom-made and applied by your doctor or an assistant.
Casts can be made of plaster or fiberglass. Splints or half
casts also can be custom-made, especially if an exact fit
is necessary. Other times, a ready-made splint will be used.
These off-the-shelf splints are made in a variety of shapes
and sizes, and are much easier and faster to use. They have
Velcro straps which make the splints easy to adjust, and
to put on and take off. Your doctor will explain both how
to use your injured arm or leg while it is healing and how
to adjust your splint to accommodate swelling.
What
Materials Are Used In Casts And Splints?
Fiberglass or plaster materials form the hard supportive
layer in splints and casts. Fiberglass is lighter in weight,
longer wearing, and "breathes" better than plaster.
Plaster is less expensive than fiberglass and for some uses
shapes better than fiberglass. Both materials come in strips
or rolls which are dipped in water and applied over a layer
of cotton or synthetic padding covering the injured area.
X-rays to check the healing process of an arm or leg within
a splint or cast penetrate or "see through" fiberglass
better than plaster.
How
Are Casts And Splints Applied?
Both fiberglass and plaster splints and casts use padding,
usually cotton, as a protective layer next to the skin.
The splint or cast must fit the shape of the injured arm
or leg correctly to provide the best possible support. Generally,
the joint above and below the fractured bone also is covered
by the splint or cast. Frequently, a splint is applied to
a fresh injury first and, as swelling subsides, a full cast
may be used to replace the splint. Sometimes, it may be
necessary to replace a cast as swelling decreases and the
cast "gets too big." Often as a fracture heals,
a splint may be applied again to allow easy removal for
therapy.
Getting
Used To The Splint Or Cast
If your treatment is to be successful, you must follow your
doctor's instructions carefully. The following information
provides general guidelines only, and is not a substitute
for your doctor's advice.
Swelling
due to your injury may cause pressure in your splint or
cast for the first 48 to 72 hours. This may cause your injured
arm or leg to feel snug or tight in the splint or cast.
To reduce the swelling:
- Elevate
your injured arm or leg above your heart by propping it
up on pillows or some other support. You will have to
recline if the splint or cast is on your leg. Elevation
allows clear fluid and blood to drain "downhill"
to your heart.
- Move
your uninjured, but swollen fingers or toes gently and
often.
- Apply
ice to the splint or cast. Place the ice in a dry plastic
bag or ice pack and loosely wrap it around the splint
or cast at the level of the injury. Ice that is packed
in a rigid container and touches the cast at only one
point will not be effective.
Warning
Signs Following Cast Or Splint Application
After application of a splint or cast, it is very important
to elevate your injured arm or leg for 24 to 72 hours. The
injured area should be elevated well above the heart. Rest
and elevation greatly reduce pain and speed the healing
process by minimizing early swelling. If you experience
any of the following warning signs, contact your doctor's
office immediately for advice.
-
Increased pain, which may be caused by swelling, and the
feeling that the splint or cast is too tight.
- Numbness
and tingling in your hand or foot, which may be caused
by too much pressure on the nerves
- Burning
and stinging, which may be caused by too much pressure
on the skin
- Excessive
swelling below the cast, which may mean the cast is slowing
your blood circulation
- Loss
of active movement of toes or fingers, which requires
an urgent evaluation by your doctor
Taking
Care Of Your Cast Or Splint
-
After you have adjusted to your splint or cast for a few
days, it is important to keep it in good condition. This
will help your recovery.
- Keep
your splint or cast dry. Moisture weakens plaster and
damp padding next to the skin can cause irritation. Use
two layers of plastic or purchase waterproof shields to
keep your splint or cast dry while you shower or bathe.
- Do
not walk on a "walking cast" until it is completely
dry and hard. It takes about one hour for fiberglass,
and two to three days for plaster to become hard enough
to walk on.
- Keep
dirt, sand, and powder away from the inside of your splint
or cast.
- Do
not pull out the padding from your splint or cast.
- Do
not stick objects such as coat hangers inside the splint
or cast to scratch itching skin. Do not apply powders
or deodorants to itching skin. If itching persists, contact
your doctor.
- Do
not break off rough edges of the cast or trim the cast
before asking your doctor.
- Inspect
the skin around the cast. If your skin becomes red or
raw around the cast, contact your doctor.
- Inspect
the cast regularly. If it becomes cracked or develops
soft spots, contact your doctor's office.
Proper
Cast Removal
Never remove the cast yourself. You may cut your skin or
prevent proper healing of your injury. Your doctor will
use a cast saw to remove your cast. The saw vibrates, but
does not rotate. If the blade of the saw touches the padding
inside the hard shell of the cast, the padding will vibrate
with the blade and will protect your skin. Cast saws make
noise and may feel "hot" from friction, but will
not harm you—their "bark is worse than their
bite."
Use
common sense. You have a serious injury and you must protect
your cast from damage so it can protect your injury while
it heals. After initial swelling has subsided, proper splint
or cast support will usually allow you to continue your
daily activities with a minimum of inconvenience.
Take
care of your cast and it will take care of you.
Return
to top of page
Additional
Orthopedic Conditions
Ankle
Sprains
|
Anterior
Cruciate Ligament (ACL) Injuries
|
Anterior
Knee Pain
|
Arthritis
|
Diabetic
Foot Problems
|
Feet
- Common Foot Problems
|
Fractures
|
Hands
- Common Hand Problems
|
Lower
Back Pain
|
MCL
(Medial Collateral Ligament ) Sprain
|
Meniscal
Injuries
|
Neck
Pain
|
Osteoporosis
|
Scoliosis
|
Shoulder
Pain
|
Sprains
and Strains
Additional
Preventative Care, Procedures & General Information
Arthroscopy
|
Back
Care |
Back
Pain and Lifting Safely
|
Broken
Hips - Prevention
|
Cast
and Splint Car
|
Climbing
Safely
|
Driving
Safely
|
Falls
- All About Falls
|
Joint
Replacement (Total)
|
Orthopedics
|
Playground
Safety Checklist
|
Sledding
Safely
|
Stay
Active, Stay Safe
|
Young
Athletes - Safety Tips
Return
to top of page |